3–48. After the items of test equipment are placed into the MEASURE proqram, what will be the first indication  that  the  applicable  test equipment is in the proqram? 1. The activity will receive a formal letter stating which items are placed into the MEASURE  program 2. The  activity  will  receive copies of the MEASURE TMDE inventory  report  forms  that  it previously  submitted;  each  item accepted  will  have  stamped “Approved for MEASURE” 3. The activity will receive a printed inventory and a set of preprinted  Metrology  Equipment Recall  and  Report  (METER)  cards 3–49. Which  of  the  following  MEASURE formats are distributed on a monthly  basis  to  the  customer activity? 1. Format  310  (Test  Equipment Inventory)  and  Format  350  (Test Equipment  Inventory  in Subcustodian  order) 2. Format 801 (Recall Schedule, On–Site  Equipment)  and  Format 802  (Recall  Schedule,  Equipment Due In Laboratory) 3. Format 215 (Unmatched Listing) 4. Both 2 and 3 above 3–50. Who is responsible for the clarity, accuracy, and com– pleteness of the TMDF  inventory  form? 1. Calibration  activity 2. TYCOM 3. Customer  activity 4. National  Bureau  of  Standards 3-51. What  information  is  placed  in blocks 32 through 46 of the TMDE inventory  form? 1. Serial number 2. Model part number 3. Nomenclature 4. Subcustodian 3–52. 3–53. 3–54. 3–55. What  information  is  contained  on MEASURE  Format  335? 1. MEASURE  customer  codes 2. TAMS and standards reported as requiring  service  on–site 3. Equipment  history 4. MEASURE  laboratory  codes Which of the MEASURE formats is the test  equipment  coordinator’s  best tool for managing the command’s test  equipment  inventory? 1. Format  215 2. Format 310 3. Format 350 4. Format 802 When you submit changes to information for items on MEASURE Format 310, what maximum length of time should you allow for the changes to be reflected on a new monthly Format 310 before you resubmit  corrected  MEASURE  METER cards  to  correct  the  discrepancy? 1. 30  days 2. 60  days 3. 90  days 4. 120 days Which of the following actions should you take if the item of test equipment to be calibrated fails to check out with the T–1 and the R–1 MRC? 1. Tag the item, noting the discrepancy,    then forward it to the  calibration  facility  for repair  and  calibration 2. Tag the equipment and note the malfunction 3. Repair the item before sending it to the calibration facility; if you cannot repair the item, send it to a repair facility accompanied by a job order 4. Both 2 and 3 above 24