3-61.
The TIMING/STORED/CORRECTED
switch is set to the STORED
position. Which of the
following signals will the DTS
use for frame timing
synchronization?
1. The frame timing reference
stored during Net Sync
2.
The frame timing reference
obtained from the preamble
of the current message only
3. The frame timing reference
obtained at each data frame
of the current message only
4. Both the frame timing
reference obtained during
the preamble and the frame
timing of each frame of the
current message
3-62.
When the ERROR CORRECT/LABEL
switch is in the CORRECT
position, the DTS is capable of
performing which of the
following operations?
1.
Detecting and correcting an
even number of bit errors in
the received data word
2.
Detecting and correcting an
odd number of multiple bit
errors in the received data
word
3.
Detecting and correcting a
single bit error in each
received data word
4.
Detecting and correcting a
single bit error in the
received data message
3-63.
When you depress the TRANSMIT
RESET switch on the TADIL A
control panel, it causes the
DTS to perform which of the
following operations?
1.
To immediately stop all
transmissions
2.
To inhibit the generation of
output data requests,
generating a stop code and
ending the current
transmission
3.
To place the radio in radio
silence
4.
To inhibit the generation of
input data requests,
generating a stop code and
ending the current reception
3-64.
The DTS is configured as a
picket station in roll call
mode. When you depress the
TRANSMIT INITIATE switch on the
TADIL A control panel, it will
cause the DTS to perform which
of the following operations, if
any?
1.
To immediately transmit the
data
2.
To allow the unit to enter
the net
3. To assume control of the net
as NCS
4. None
3-65.
On the NCS platform, the MISS
CALL indicator on the TADIL A
panel will light when a picket
fails to respond to two
successive interrogations.
1. True
2.
False
3-66.
The address entered into the
OWN STATION ADDRESS switches
perform which of the following
DTS functions?
1.
Transmits the entered
address to all other members
of the net
2.
Transmits the entered
address to NCS only
3. Receives messages that match
the entered address
4.
Transmits tactical data when
the interrogation message
address matches the entered
address
3-67.
On the NCS platform operating
in a Link-11 net where the
units are approximately 100
miles apart, which of the
following values should be
entered into the RANGE IN MILES
switches?
1.
0 miles
2.
25 miles
3.
50 miles
4.
100 miles
17