3-52. When the DTS is in the OPERATE mode, exactly how many fault- sensing sensors can cause the SUMMARY FAULT lamp to light? 1. 11 2. 14 3. 23 4. 27 3-53. The LAMP TEST switch on the Mode Control Panel will cause all of which of the following lamps  to  light? 1. Those on the mode control panel only 2. Those on the TADIL A control panel only 3. Those on the address control unit only 4. Those on the mode control panel, the TADIL A control panel, and the address control  unit 3-54. When the FULL-DUPLEX/HALF- DUPLEX switch is in the FULL- DUPLEX POSITION, the transmit sidetone is processed for input to the computer. 1. True 2. False 3-55. When the SIDEBAND SELECT switch is in the DIV position, which sideband signal is processed for input to the computer? 1. USB only 2. LSB only 3. The combination of the USB and LSB signals 4. Either the USB or the LSB, depending on the signal quality of each sideband 3-56. During normal Link-11 operations, the DATA RATE switch on the mode control panel should be in which of the following   positions? 1. 1,200 bps 2. 2,400 bps 3. DUAL 1,200 bps 4. TADIL A 3-57. 3-58. 3-59. 3-60. 16 The SYNC MODE switch on the mode control panel is used in conjunction with which of the following switches on the TADIL A control panel? 1. OPERATE/RADIO SILENCE switch 2. NET CONTROL/PICKET switch 3. TIMING STORED/CORRECTED switch 4. ERROR CORRECT/LABEL switch When the SYNC MODE switch is placed  in  the  FAST  position, synchronization is obtained by which of the following methods? 1. 2. 3. 4. Use of the frame timing reference stored during Net Sync Use of the frame timing reference obtained from the preamble of, the current message only Use of the frame timing reference obtained at each data frame of the current message only Use of both the frame timing reference obtained during the preamble and the frame timing of each frame of the current  message The NET BUSY indicator of the TADIL A control panel is activated by which of the following  signals? 1. Signal presence 2. Receive  mode 3. Transmit mode 4. Start code detected The SYNC COMPT indicator is lighted after the DTS has achieved which of the following conditions? 1. It is in sync with the radio 2. It is using stored synchronization signals 3. It is in sync with NCS 4. It is testing the internal sync  circuits