5–14. What section of the PEETE Index should you use to find out what equipments  use  a  particular  SCAT code? 1. Section I 2. Section II 3. Section III 4. Section V 5–15. What section should you use to locate  the  models  of  test  equipment that may satisfy a particular SCAT code? 1. Section II 2. Section  IV 3. Section  V 4. Section VI 5–16. Refer to figure 7–7 in the TRAMAN. What  appendix  should  you  use  to determine a stock number from a known  SCAT  code? 1. Appendix A 2. Appendix B 3. Appendix C 4. Appendix D 5-17. In  addition  to  ship  support requirements,  the  quantity  of  each SCAT also depends on which of the following  factors? 1. The location of prime equipments  and  systems,  and  the number of these prime equipments  and  systems installed 2. The  frequency  of  test  equipment usage, and the ability to share test  equipment  among  different divisions 3. The portability of the test equipment,  and  the  number  of personnel  that  use  the  test equipment 4. All of the above 5–18. At which of the following times should the SPETERL be “bumped” against  the  COSAL? 1. Annually 2. Semiannually 3. Only at the completion of overhaul 4. Before  a  major  deployment 5–19. To  report  a  PEETE  configuration change, you should use which of the following  forms? 1. OPNAV  4790/2K 2. OPNAV  4790/2L 3. OPNAV  4790/2P 4. OPNAV  4790/CK 5–20. Refer to figure 7-9 in the TRAMAN. After bumping the SPETERL and COSAL against  one  another,  you  find  that a  particular  piece  of  test equipment required for PMS is on board and is listed in the SPETERL, but is not listed in the COSAL. What is the possible cause? 1. A  deficiency  in  allowance 2. A change in quantity was not reported 3. Configuration  changes  were  not reported 4. PMS  requirements  were  not reported  to  NAVSEALOGSUPENGACT 5–21. When  using  OPNAV  Form  4790/CK  to report a turn–in or receipt of PEETE, you do not need to check the configuration  file  correction  block at the top of the form. 1. True 2. False 5–22. To  determine  what  GPETE  excesses and deficiencies exist on board, you should look at what GPETE is on board. Which  of  the  following sources/references  should  you  use to  determine  the  GPETE  allowance? 1. Current  SCLSIS 2. Current  SPETERL 3. Approved  ACRs 4. Both 2 and 3 above 31