14-41. 14-42. 14-43. 14-44. 14-45. On KCMX ready analog inputs, which of the following types of conversion is performed? 1.    Digital-to-linear 2.    Digital-to-synchro 3.    Linear-to-digital 4.    Synchro-to-digital The KCMX uses what maximum number of reference voltages to perform synchro-to- digital conversions on ready analog inputs? 1.   8 2. 12 3. 16 4. 20 The computer input data register is located on which of the following KCMX panels? 1.    Al 2. A2 3. A3 4. A4 The DD/DDI select ON/OFF switches on the KCMX perform which of the following functions? 1. They identify the group mode 2. They indicate if an ENTER signal is on the line 3. They enable or disable the individual device DDI enter signals 4.  All  of  the  above Which of the following KCMX controls/ indicators indicates the status of individual external signals? 1.  Data  register 2.   Output   register 3.  Control  output  register 4.  Computer  input  data  register 14-46. 14-47. 14-48. 14-49. 14-50. 120 DOC equipment output data maybe viewed using which of the following registers? 1.  Data  register 2.  Output  register 3.  Control  output  register 4.  Computer  input  data  register Which of the following duplex controls/ indicators are lighted to indicate that computer A is in control of the KCMX and has received an input data request from computer A? 1.  The  A  ODR  only 2.  The  A  IDR  only 3.  The  A  IN  CONTROL  only 4. Both the A IDR and the A IN CONTROL Which of the following MODE SELECT switch positions enables the KCMX to simulate computer operations by use of the front panel controls? 1.  DOC 2.   MANUAL 3.   NORM 4.  A/D  CONV Which of the following KCMX pushbuttons is used to reset all logic circuits? 1.  BFE 2.  DATA 3.   MASTER   CLEAR 4.   ADDRESS   CLEAR Which of the following KCMX indicators may be used to display the starting address of a set of addresses to be interrogated in test mode? 1. 2. 3. 4. INTERRUPTS FINAL  ADDRESS ADDRESS  CLEAR CURRENT  ADDRESS