Table 5-4.-Intersection Connector Code
Table 5-5.-CSCP Connector Code
The CSCP uses two types of connectors, a lo-pin
connector and an 85-pin connector. The 10-pin
connectors are designated JA, JB, JN, and JP. The
85-pin connectors are designated JC through JG, JH,
and JK. The alphanumeric identification shown in table
5-5 is used for CSCP connectors.
Analog switchboards are similar design to the Mk
70 DFCS. The switchboard is made up of a variable
number of switchboard sections. The number of
sections required will vary with the analog interface
requirements of the shipboard system.
Each switchboard section consists of front and rear
cabinets (fig. 5-15). The front cabinet contains the panel
assemblies. The rear cabinet contains removable
modules on which are mounted the ships cable
Each switchboard section contains 36 panels of
various types mounted on the door of the front cabinet.
The panels are numbered starting with panel 1 in the
upper left-hand corner in section 1 and progress
consecutively downward in each column and
successively to the right. The door in each switchboard
section allows access to the section interior.
Ships cables enter the switchboard through the rear
cabinet and connect to the front of the module terminal
Figure 5-15.-Analog switcbboard.