14-10.14-11.14-12.14-13.What is the total number of stator voltagesrequired to determine the ratio angle oncethe sector has been determined?1. One2. Two3. Three4. FourDuring the octant conversion process, the45-degree octant is determined by which ofthe following means?1. The polarity and amplitude of two of thestator voltages2. The polarity and amplitude of the sineand cosine voltages3. The phase difference between two of thestator voltages4. The phase difference between the sineand cosine voltagesOnce the octant has been determined duringthe octant conversion process, the remainingbit positions of the BAM word aredetermined by a trial and errorapproximation of a test binary angle againsta ratio angle.1. True2. FalseWhat total number of synchro-to-digitalconversions are required to generate a singleBAM word from a dual-speed synchroinput?1. One2. Two3. Eight4. Four14-14.14-15.14-16.14-17.14-18.Linear signals normally represent a quantitybased on which of the followingcharacteristics?1.2.3.4.Signal amplitudeSignal frequencySignal phase relationshipAll of the aboveScalar or resolver outputs are comprised ofwhich of the following signals?1. A single linear waveform2. A single waveform representing the sineof an angle3. A single waveform representing thecosine of an angle4. Two waveforms representing the sine andcosine of an angleThe binary input to digital-to-analogconverters is normally in which of thefollowing binary forms?1. Binary-coded decimal2. Gray code3. Binary angular measurement word4. Natural binaryA single digital-to-analog converter outputswhat maximum number of proportionalvoltage signals?1. One2. Two3. Three4. FourWhat maximum number of DACs canbe mounted on a mounting base?1. One2. Two3. Three4. Four117